Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-110
TCP Maximum Retries (continued)
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
TCP/IP Maximum Transmit Timeout
Purpose: Defines the maximum timeout that TCP will allow between retries of a transmission in a
TCP/IP direct connect network before it gives up. For example, 20 means that the
timeout between retries is never longer than 20 seconds. Intermec has determined that the
optimum setting is 20 seconds.
Syntax: NHdata
Acceptable values for data are:
0 No timeout
1-128 Transmit timeout in seconds
Default: 20 seconds
Scan: To set the default TCP/IP Maximum Transmit Timeout, scan this bar code:
Default TCP/IP Maximum Transmit Timeout
*$+NH20*
*$+NH20*
Or: To set the TCP/IP maximum transmit timeout:
1. Scan this bar code:
Enter Accumulate Mode / Set TCP/IP Maximum Transmit Timeout
*+/$+NH*
*+/$+NH*