Intermec Antares 2420

nuggetf
code39
Getting Started
1-35
1
What’s New on the TRAKKER Antares Terminals
The firmware on the terminals has been updated and expanded. These new features for
the terminals were added in the v5.X firmware release:
• Information is included about usng the
APPTSK.BIN
and
EM9560.BIN
applications
that are preloaded on the terminals. The EM9560.BIN application leets you emulate
specific features that are available on Intermec 95XX terminals. For help, see
Appendix D, “Using the Default Applications.”
• You now use a programmable terminal instead of a screen mapping terminal to do
screen mapping with the host through the DCS 300.
• Information is included about using the serial interface module for COM4.
• Information is included about using the modem for COM3.
• XON/XOFF is allowed in Frame mode. For help, see “Flow Control” in Chapter 9.
• New Set Time and Date reader command for 95XX terminal compatibility. For help,
see “Set Time and Date” in Chapter 8.
Where Do You Go From Here?
Now that your new terminal is working, you can use this manual to learn how to perform
these tasks:
Task or Feature See This Chapter
To learn how to use the terminal’s
keypad, screen, audio signals, batteries,
and scan module
Chapter 2, “Learning How to Use the Terminal”
To learn how to change the terminal’s
configuration
Chapter 3, “Configuring the Terminal”
To add the terminal to your Intermec
2.4 GHz RF network or wired data
collection system and learn how to
communicate with other devices
Chapter 4, “Operating the Terminal in a
Network”
To learn how to download and run
custom applications on your
programmable terminal
Chapter 5, “Using Custom Applications”
To learn how to reset the terminal, solve
problems, and respond to error messages
Chapter 6, “Troubleshooting”
To learn how to run diagnostics and
check the battery power remaining
Chapter 7, “Running Diagnostics”