Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
N
ugg
Co de 39
8-20
Rename File
Purpose: Renames a file stored on the terminal.
From Network: ...-
drive:oldfilename,drive:newfilename
where:
...- is the command to rename a file.
drive: indicates the drive where the oldfilename is stored. You must include
the colon (:) after the drive letter.
oldfilename is the name of the file you want to rename.
drive: indicates the drive where the newfilename is stored. You must include
the colon (:) after the drive letter. The drive letter MUST match the
drive letter you entered for the oldfilename.
newfilename is the new name of the file.
Keypad: In the TRAKKER Antares 2400 Menu System, choose System Menu and then choose
File Manager. Next, choose the drive where you want to rename files.
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Rename File
*+/...-*
*+/...-*
2. Scan the bar code label(s) for the file you want to rename. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B. The label must use this format:
drive:oldfilename,drive:newfilename
3. Scan this bar code label to exit Accumulate mode and rename the file.
Exit Accumulate Mode
*-/*
*-/*
Or: You can create your own bar code labels to rename files by creating a bar code in this
command format:
...- drive:oldfilename,drive:newfilename
Example: To rename the file
SHIPPING.BIN
on drive C to
DOCK1.BIN
, use this command:
...-c:shipping.bin,c:dock1.bin