Intermec Antares 2420 - Verifying that the T2425 Is Communicating Correctly

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nuggetf
code39
1-30
Verifying That the T2425 Is Communicating Correctly
Once you have configured the terminal, your T2425 is ready for operation. To transmit
and receive data, the T2425 must be communicating with the access point and DCS 300
or host. Use these instructions to make sure the T2425 is communicating correctly.
To verify that the T2425 is communicating correctly
1. If the terminal is not on, press L to turn it on.
2. Look at the top line of the terminal’s screen. If the Connect icon (shown in the
illustration) appears and remains on solid, the terminal is communicating with the
access point. In a UDP Plus network, a solid Connect icon also means that the
terminal is communicating with the DCS 300. The terminal can send and receive data
to the connected devices.
*
242XU.109
If you are having problems with network communications
• If the Connect icon blinks or is not on, you need to check the network IP addresses
and configuration. Make sure the radio domain and radio security ID on the terminal
match the values that are set on the access point.
• If the Radio icon (shown in the illustration) remains on solid, the Network Activate
command is disabled, or there is a problem with the radio card and the radio is turned
off.
242XU.116
Make sure the Network Activate command is enabled and all the network parameters are
set correctly. For help, follow the instructions for “Configuring the T2425 and the RF
Network” earlier in this chapter.