nuggetf
code39
Getting Started
1-29
1
18. Press
to choose Yes and store your changes permanently in flash memory.
Store configuration
changes in flash
memory?
(used when rebooting
the terminal)
242XU.054
Yes No
CANCEL
19. Press
to choose OK and exit the TRAKKER Antares 2400 Menu System.
Exiting
TRAKKER Antares 2400
Menu System
242XU.055
OK CANCEL
The T2425 will try to establish communications with the DCS 300 or the host. For
terminal emulation applications in a UDP Plus network, you need to configure the
host name in the TE Configuration menu to establish communications. For help, see
the
TRAKKER Antares Terminal Emulation User’s Guide
.
Once the terminal connects, the login or initial screen for your application appears
and the Connect icon stops blinking. You can begin using the terminal to collect data.
Note:
While the terminal is connecting to the DCS 300 or host, the terminal
ignores any input from the keypad or scanner. Wait until the terminal is connected
before you try to enter any data.
If the terminal will not connect, see Chapter 6, “Troubleshooting,” or the
DCS 300
System Manual
.
To Next Page
Loading...
