nuggetf
code39
Getting Started
1-17
1
Setting the Time and Date
You need to set the time and date on the terminal. Use the TRAKKER Antares 2400
Menu System to set the time and date.
To set the time and date
1. Press
T3,
or press
T
or scan this bar code label to
access the TRAKKER Antares 2400 Menu System.
Enter Test and Service Mode
*..-.*
*..-.*
Note: You must press the
T
(Left Enter) key in this key sequence. The
T
key is
located just under the
L
key.
The Main Menu appears.
242XU.001
2. Press
V
to choose the System Menu and then press
. The System Menu appears.
SYSTEM MENU
File Manager
Load Default Values
Set Time and Date
Store Configuration
Upgrade Firmware
_` Select item
[Enter] Next screen
[F1] Help
[Esc] Exit
242XU.051
To Next Page
Loading...
