Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-6
Entering Variable Data in a Configuration Command
You can enter variable data for many of the configuration commands. For example, you
can set a preamble that is up to 25 ASCII characters long. You need to follow these
general instructions to enter variable data.
To enter variable data in a configuration command
1. Scan a bar code label with this syntax:
+/$+ command
where:
+/ is the syntax for the Enter Accumulate Mode command.
$+ is the syntax for the Change Configuration command.
command is the syntax for the command you want to change.
For example, the command syntax for a preamble is ADdata. To change or set a
preamble, scan this bar code:
Enter Accumulate Mode / Change Configuration / Set Preamble
*+/$+AD*
*+/$+AD*
2. Scan a bar code label from the “Full ASCII Bar Code Chart” in Appendix B. To set
the preamble to the character T, scan this label:
T
*T*
*T*
Note: To use the bar code labels in Appendix B, you may need to configure the
terminal to use Code 39 in Full ASCII mode. For help, see “Code 39” later in this
chapter.
3. Scan the Exit Accumulate Mode bar code label to update the terminal’s
configuration:
Exit Accumulate Mode
*-/*
*-/*