Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
N
ugg
Co de 39
8-24
Transmit File Via RF Communications
Purpose: Transmits a file from the T2425 and saves it on the DCS 300 or host.
From Network: %%R,
drive:fromfilename,tofilename
where:
%%R is the command to transmit a file over the RF network. The “R”
indicates a file transmitted via RF communications from the T2425 to
the DCS 300 or host.
drive: indicates the drive where the file is stored on the T2425. You must
include the colon (:) after the drive letter.
fromfilename is the name of the file you are transmitting from the T2425 to the
DCS 300 or host.
tofilename is the name of the file that will be saved on the DCS 300 or host. On
the DCS 300, the file is saved on the
D:\USERDATA
directory. To
transmit a file to the host, you need to identify the path and filename
where you want to save the file.
Note: Do not specify the pathname
D:\USERDATA
in the tofilename
field.
Keypad: Not supported
Scan: 1. Scan this bar code label:
Enter Accumulate Mode / Transmit File
*/K/O/E/ER/L*
*+/%%R,*
2. Scan the bar code label(s) for the file you want to transmit. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B. The label must use this format:
drive:fromfilename,tofilename
3. Scan this bar code label to exit Accumulate mode and transmit the file.
Exit Accumulate Mode
*-/*
*-/*
Or: You can create your own bar code labels to transmit files by creating a bar code in this
command format:
%%R, drive:fromfilename,tofilename