Co de 39
Nugget
Configuration Command Reference
9-49
9
Display Backlight Timeout
Purpose: Defines the amount of time the backlight stays on as long as there is no keypad or
scanning activity on the terminal. The backlight timeout resets each time there is activity.
This setting significantly affects the terminal’s battery life. If you set a longer backlight
timeout value, you will use the power in the main battery pack at a faster rate.
Syntax: DF
data
Acceptable values for
data
are:
00 Disabled
01-60 Timeout in seconds
Default: 10 seconds
Scan: To disable the backlight timeout, scan this bar code:
Disable Backlight Timeout
*$+DF00*
*$+DF00*
Or: To set the backlight timeout:
1. Scan this bar code:
Enter Accumulate Mode / Set Backlight Timeout
*+/$+DF*
*+/$+DF*
2. Scan a two-digit numeric value for
data
from these bar codes.
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*
*6* *7*
*6* *7*
*8* *9*
*8* *9*
To Next Page
Loading...
