Intermec Antares 2420 - Default Configuration; Multiple-Read Labels

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
N
ugg
Co de 39
8-10
Default Configuration
Purpose: Sets the terminal to its default configuration, resets the firmware, boots the terminal, and
runs your application. The default configuration for the terminal is listed in Appendix A.
For help, see “Restoring the Terminal’s Default Configuration” in Chapter 3.
When you use the Default Configuration command, the default configuration is saved in
RAM and flash memory. The runtime and boot configuration are changed to the default
configuration.
Note: In the default configuration, the Primary Network parameters are set to the
default values. The T2425 will no longer have a valid IP address and cannot
communicate with other devices. You need to configure the T2425 again. For help, see
Chapter 4, “Operating the Terminal in a Network.”
From Network: .+0
Keypad: In the TRAKKER Antares 2400 Menu System, choose System Menu and then choose
Load Default Values.
Scan:
Default Configuration
*.+0*
*.+0*
Multiple-Read Labels
Purpose: A multiple-read label is a Code 39 or Code 93 bar code label that has a space as the first
character after the start code. The terminal stores a multiple-read label in the buffer until
you execute a command to transmit the label or scan a regular label. A regular bar code
label is executed as soon as you scan it.
If you use a configuration command or the TRAKKER Antares 2400 Menu System to
disable multiple-read labels, the terminal processes the bar code label as a regular label
and reads and decodes the space as data.
From Network: Not supported
Keypad: Not supported
Label Syntax: <Start Code><SP>data<Stop Code>
where <SP> is the ASCII space character and data is the content of the label.
Example:
Multiple-Read Bar Code Label
* A*
* A*