Co de 39
Nugget
Configuration Command Reference
9-7
9
Acknowledgement Delay Lower Limit
Purpose: When the T2425 sends a message to the DCS 300, the terminal waits to receive a
response acknowledging the message. If no response is received within the
Acknowledgement Delay Lower Limit time, the terminal sends the message again at the
time interval set for the lower limit. The terminal will continue to send the data at
increasingly longer intervals until it reaches the Acknowledgement Delay Upper Limit
time. The terminal continues sending the message at the time interval set for the upper
limit until a response is received or a timeout error occurs.
Syntax: NV
data
Acceptable values for
data
are any number from 200 to 2000 ms.
Default: 300 ms
Scan: To set the default acknowledgement delay lower limit, scan this bar code:
Default Acknowledgement Delay Lower Limit
*$+NV300*
*$+NV300*
Or: To set the acknowledgement delay lower limit:
1. Scan this bar code:
Enter Accumulate Mode / Set Acknowledgement Delay Lower Limit
*+/$+NV*
*+/$+NV*
2. Scan a numeric value for
data
from these bar codes:
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*
*6* *7*
*6* *7*
To Next Page
Loading...
