Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-45
9
Data Bits
Purpose: Sets the number of data bits the terminal uses when communicating with another device
(i.e., host computer) through the serial port.
Syntax: YI
n
.
data
where
n
is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for
data
are:
7 7 data bits
8 8 data bits
Default: 7
Scan: One of these bar codes:
7 Data Bits for COM1 8 Data Bits for COM1
*$+YI1.7* *$+YI1.8*
*$+YI1.7* *$+YI1.8*
7 Data Bits for COM3 8 Data Bits for COM3
*$+YI3.7* *$+YI3.8*
*$+YI3.7* *$+YI3.8*
7 Data Bits for COM4 8 Data Bits for COM4
*$+YI4.7* *$+YI4.8*
*$+YI4.7* *$+YI4.8*
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
II
data
where
data
is a value or 7 or 8.