Intermec Antares 2420

Configuring the Terminal
3-19
3
Restoring the Terminal’s Default Configuration
When you configure the terminal according to the instructions presented in this chapter,
the parameters remain in effect until you reconfigure them. If you configure the terminal
but do not save your changes in flash memory, the parameters will remain in effect until
you boot or reset the terminal.
The default configuration for the terminal is listed in Appendix A. You can use the
TRAKKER Antares 2400 Menu System or scan the Default Configuration bar code label
to return the terminal to its default configuration.
Note:
If you restore the default configuration, you need to set the primary network
communications parameters on the T2425 to reestablish communications with other
devices in the 2.4 GHz RF network. You may also need to reset the serial port
parameters to communicate with another device through the serial port.
To restore the default configuration using the reader command
• Scan this bar code label:
Default Configuration
*.+0*
*.+0*
To restore the default configuration using the menu system
1. Press T3, or scan this bar code:
Enter Test and Service Mode
*..-.*
*..-.*
The Main Menu appears.
2. Choose System Menu and press  . The System Menu appears.