TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-90
RF Domain
Purpose: Defines a logical partition or subnetwork of the network. To establish communications,
you must assign the same domain number to every RF device in a wireless network. The
domain number you set on the T2425 must match the domain that is set on each access
point the T2425 may communicate with. You can continue to collect data with the T2425
as you roam in between access points as long as all the devices have the same domain
number.
Syntax: RWdata
Acceptable values for data are any number from 0 to 15.
Default: 0
Scan: 1. Scan this bar code:
Enter Accumulate Mode / Set RF Domain
*+/$+RW*
*+/$+RW*
2. Scan a numeric value for data from these bar codes:
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*
*6* *7*
*6* *7*
*8* *9*
*8* *9*
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
To Next Page
Loading...
