Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-25
9
Code 49
Purpose: Enables or disables decoding of Code 49 symbology. Code 49 is a multirow symbology
for high data density. The last character in each row is used for row checking and the last
two characters of the symbol are used for overall checking.
Function codes designate where to place the predefined data string in a Code 49 label.
Whenever a terminal encounters a function code, it replaces the function code with the
defined string before transmitting the data to the DCS 300. A single Code 49 symbol may
contain several different variable length data fields. Function Code 1 (F1) identifies a
data system. Function Code 2 (F2) indicates the end of a data field.
Syntax: CJ
data
Code 49
CK
data
Function Code 1
CL
data
Function Code 2
CM
data
Function Code 3
Acceptable values for
data
are:
Code 49 (CJ): 0 Disabled
1Enabled
Function Code 1 (CK): Any two ASCII characters.
Function Code 2 (CL): Any four ASCII characters
Function Code 3 (CM): Any two ASCII characters
Default: Disabled
Scan: One of these bar codes:
Disable Code 49 Enable Code 49
*$+CJ0* *$+CJ1*
*$+CJ0* *$+CJ1*
Scan: To disable any of the function codes, scan one of these bar codes:
Disable Function Code 1 Disable Function Code 2
*$+CK* *$+CL*
*$+CK* *$+CL*
Disable Function Code 3
*$+CM*
*$+CM*