Intermec Antares 2420 - Terminal IP Address

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-112
Terminal IP Address
Purpose: Defines the IP address assigned to the T2425 in your 2.4 GHz RF network. An IP
address is a unique network level address you assign to each device in a TCP/IP network.
The IP address you set on the T2425 must match the address that is set on the DCS 300
or host computer.
Syntax: NDn.n.n.n
where each n address segment is a number from 0 to 255. The terminal IP address field
consists of four separate numbers, each separated by a period.
Note: The RF network cannot be activated if the first address segment in the IP address
is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Scan: To set the default terminal IP address, scan this bar code:
Default Terminal IP Address
*$+ND0.0.0.0*
*$+ND0.0.0.0*
Or: To set the terminal IP address:
1. Scan this bar code:
Enter Accumulate Mode / Set Terminal IP Address
*+/$+ND*
*+/$+ND*
2. Scan a numeric value from 0 to 255 to set an n field of the terminal IP address from
these bar codes.
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*