Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-58
Flash Memory Configuration (continued)
Note: When you boot or reset the terminal, any fonts or files in flash memory are
erased.
4. If you configured the flash memory to store double-byte fonts, use the TRAKKER
Antares Font Editor to download the double-byte font set to the terminal. See your
local Intermec sales representative for information about the TRAKKER Antares
Font Editor.
Flow Control
Purpose: Regulates the data transmission through the serial port. The terminal is a DTE (Data
Terminal Equipment) device. There are several flow control options:
• CTS checking where Clear To Send (CTS) is a hardware signal flow control. The
terminal sets and clears Request To Send (RTS) when it is ready to receive. The
terminal checks CTS when it tries to transmit data.
• XON/XOFF response causes the terminal to respond to XON/XOFF characters
received while transmitting.
• XON/XOFF control specifies that the terminal transmits XON/XOFF characters to
control the incoming data flow.
• XON/XOFF response and control specify that the terminal responds to and transmits
XON/XOFF characters.
• CTS/RTS for DTE-DTE allows for peer connections. Each terminal’s RTS output
pin is connected to the CTS input pin of the other terminal. Each terminal sets RTS
whenever it is ready to receive data and waits for CTS to be set before sending data.
Note: For TRAKKER Antares firmware version 4.X and earlier, you must disable the
EOM command (use Character mode) to enable Flow Control with the XON/XOFF
options.
Syntax: YLn.data
where n is:
1 COM1 port
3 COM3 port
4 COM4 port