Co de 39
Nugget
Configuration Command Reference
9-77
9
Network Loopback
Purpose: Transmits all messages received from the DCS 300 back to the DCS 300. Messages
received by the radio are not passed on to the T2425 applications unless they are
configuration commands. Messages continue to be looped back to the DCS 300 as long
as this feature is enabled. Messages originating from the T2425 are still transmitted to
the DCS 300.
Use the Network Loopback parameter to troubleshoot RF communications problems.
Syntax: NL
data
Acceptable values for
data
are:
0 Disabled
1Enabled
Default: Disabled
Scan: One of these bar codes:
Disable Network Loopback Enable Network Loopback
*$+NL0* *$+NL1*
*$+NL0* *$+NL1*
To Next Page
Loading...
