Co de 39
Nugget
Configuration Command Reference
9-95
9
RF Wakeup On Broadcast
Purpose: Determines if the T2425 can receive broadcast messages sent from the network. If the
wakeup on broadcast is enabled, the T2425 radio will turn on to receive broadcast
messages. If this command is disabled, the terminal radio will ignore broadcast messages.
Power Management Tip:
If your network has many broadcast messages, you may want
to disable the wakeup on broadcast command to preserve the main battery pack’s
power.
Syntax: RB
data
Acceptable values for
data
are:
0 Disabled
1Enabled
Default: Disabled
Scan: One of these bar codes:
Disable RF Wakeup On Broadcast Enable RF Wakeup On Broadcast
*$+RB0* *$+RB1*
*$+RB0* *$+RB1*
Scan Ahead
Purpose: Enables or disables scan ahead. If you enable this parameter, you can scan a number of
labels that are held in a stack until the terminal can process the data. If you disable this
parameter, the terminal processes each label you scan before you can scan the next label.
Syntax: SD
data
Acceptable values for
data
are:
0 Disabled (scan one label at a time)
1 Enabled (scan many labels at a time)
Default: Disabled
Scan: One of these bar codes:
Disable Scan Ahead Enable Scan Ahead
*$+SD0* *$+SD1*
*$+SD0* *$+SD1*
To Next Page
Loading...
