Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-71
9
Modem Dial Sequence
Purpose: Defines the dialing sequence that is used when the terminal establishes a modem
connection.
Syntax: YD3.
data
where
data
can be up to 25 characters from this table.
Character Description
0-9 DTMF digits 0 through 9
A-D DTMF letters A through D
* The star digit (tone dialing only)
# The gate digit (tone dialing only)
W Wait for dial tone
@ Wait for silence
& Wait for credit card dialing tone
,Pause
( Ignored. You can use this character to format the dial sequence.
) Ignored. You can use this character to format the dial sequence.
- Ignored. You can use this character to format the dial sequence.
. Ignored. You can use this character to format the dial sequence.
<space> Ignored. You can use this character to format the dial sequence.
Default: 0 (no dial sequence)
Scan: To set the default modem dial sequence, scan this bar code:
Default Modem Dial Sequence
*$+YD3*
*$+YD3*
Or: To set the modem dial sequence for COM3:
1. Scan this bar code:
Enter Accumulate Mode / Set Modem Dial Sequence
*+/$+YD3*
*+/$+YD3*