Co de 39
Nugget
Configuration Command Reference
9-15
9
Beep Volume
Purpose: Adjusts the volume of the terminal’s audio signals. For a list of all the beep sounds and
audio signals, see “Understanding the Terminal’s Audio Signals” in Chapter 2. Set the
beep and keyclick volume according to operator preference and work environment.
Note:
If the Beep Volume command is set to off, you will not hear any audio signals
including the keyclick.
Syntax: BV
data
Acceptable values for
data
are:
0Off
1Quiet
2Normal
3Loud
4Very loud
8 Lower volume
9 Raise volume
Default: Very loud
Scan: One of these bar codes:
Beep Volume Off Beep Volume Quiet
*$+BV0* *$+BV1*
*$+BV0* *$+BV1*
Beep Volume Normal Beep Volume Loud
*$+BV2* *$+BV3*
*$+BV2* *$+BV3*
Beep Volume Very Loud
*$+BV4*
*$+BV4*
Or: Scan one of these bar codes repeatedly to achieve the desired volume:
Raise Beep Volume Lower Beep Volume
*$+BV9* *$+BV8*
*$+BV9* *$+BV8*
To Next Page
Loading...
