Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-10
Acknowledgement Delay Upper Limit (continued)
*8* *9*
*8* *9*
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Append Time
Purpose:
Appends the time to bar code labels that are scanned on the terminal. You can also use
the Time in Seconds command to append the time in hours and minutes only, or hours,
minutes, and seconds. The time is appended to the data in the form HH:MM:SS. For
help, see “Time in Seconds” later in this chapter.
Syntax:
DE
data
Acceptable values for
data
are:
0 Disabled
1Enabled
Default:
Disabled
Scan:
One of these bar codes:
Disable Append Time Enable Append Time
*$+DE0* *$+DE1*
*$+DE0* *$+DE1*