Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-83
9
Poll (Polling)
Purpose: Solicits or requests data from a polled device.
Note:
Before you can enable Poll, you must configure the EOM and Handshake
commands.
Syntax: YR
n
.
data
where
n
is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for
data
are:
Disabled No polling
Enabled Set to FS (hexadecimal value of \x1C)
Default: Disabled
Scan: To disable poll, scan one of these bar codes:
Note:
To scan these bar code labels, you must configure the terminal to use Code 39 in
Full ASCII mode. For help, see “Code 39” earlier in this chapter.
Disable Poll for COM1 Enable Poll (Set to FS) for COM1
*/D/KYR1.* */D/KYR1.%B*
*$+YR1.* *$+YR1.%B*
Disable Poll for COM3 Enable Poll (Set to FS) for COM3
*/D/KYR3.* */D/KYR3.%B*
*$+YR3.* *$+YR3.%B*
Disable Poll for COM4 Enable Poll (Set to FS) for COM4
*/D/KYR4.* */D/KYR4.%B*
*$+YR4.* *$+YR4.%B*
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
HB
data
where
data
is disabled or enabled (set to FS).