Intermec Antares 2420

Nugg
Co de 39
Reader Command Reference
8-11
8
After you scan a multiple-read bar code label, the accumulated data appears on the
bottom line of the terminal screen. You can use the Accumulate mode commands, such as
Backspace or Clear, to accumulate data. Once you scan a non-multiple-read label, the
data is entered.
Reset Firmware
Purpose: Resets all firmware on the terminal, resets the application, and runs the application. You
can use the Reset command to restart your application if you are having problems.
Note:
You can also try resetting the hardware if your application or terminal is locked
up and the terminal will not respond to any other commands. For help, see “Booting
and Resetting the Terminal” in Chapter 6.
From Network: -.
Keypad: Not supported
Scan:
Reset Firmware
*-.*
*-.*
Save Configuration in Flash Memory
Purpose: Saves the current runtime terminal configuration in flash memory. If you configure the
terminal by scanning bar code labels or commands sent from a network device, your
configuration changes are only saved in RAM. You can use this reader command to save
the changes to flash memory so that they are set the next time you boot or reset the
terminal.
From Network: .+1
Keypad: In the TRAKKER Antares 2400 Menu System, choose System Menu and then choose
Store Configuration.
Scan:
Save Configuration in Flash Memory
*.+1*
*.+1*