Intermec Antares 2420 - Running Diagnostics from the Menu System

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugg
Co de 39
7-4
Diagnostic Tests (continued)
Diagnostic Test Description
Malloc Application
Information
Shows how memory is allocated and used by the current
application.
Malloc Firmware
Information
Shows how memory is allocated and used in the terminal
firmware.
Radio Test (T2425 only) Tests the radio to make sure it is working.
Serial Loopback Verifies that the hardware for the RS-232 serial port is
functioning correctly.
Scanner Test Tests the laser scanner to make sure it is working.
Serial Port Test Tests serial communications between the terminal and the
host computer or serial device.
Subsystem Versions Lists the version of each major firmware subsystem loaded
on the terminal.
Task Status Shows the task name, stack, the percentage of time each
subsystem has been running, and the stack usage.
Running Diagnostics From the Menu System
The TRAKKER Antares 2400 Menu System is a menu-driven application that lets you
configure the terminal, view system information, and run diagnostics. You can access the
TRAKKER Antares 2400 Menu System and run diagnostics while running any
application.
To run diagnostics from the TRAKKER Antares 2400 Menu System
1. Press
T3, or scan this bar code:
Note: You must press the T (Left Enter) key in this key sequence.
Enter Test and Service Mode
*..-.*
*..-.*