Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-55
9
End of Message (EOM)
Purpose: Attaches an EOM to the end of a data block to indicate the end of data transmission to
and from a terminal. When EOM is disabled, the terminal communicates in Character
mode. When EOM is enabled, the terminal communicates in Frame mode.
You must configure a value for EOM before you can set these other serial
communications commands:
• Configuration Commands Via Serial Port
• Handshake
• LRC
• Start of Message (SOM)
EOM cannot equal the same value that is set for SOM. You cannot set EOM to any of
these values:
• AFF (ACK) • REQ (ENQ)
• DLE • SEL
• NEG (NAK) • XOFF
• Poll • XON
• RES (EOT)
Syntax: YZ
n
.
data
where
n
is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for
data
are one or two ASCII characters.
Default: \x03 (hexadecimal value for ETX)
Scan: To disable EOM, scan one of these bar codes:
Disable EOM for COM1 Disable EOM for COM4
*$+YZ1.* *$+YZ4.*
*$+YZ1.* *$+YZ4.*