Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugget
Co de 39
6-22
Using the Boot Menu
The Boot menu appears after you:
• remove both batteries, install them again, and turn on the terminal.
• upgrade the firmware.
• reset the terminal.
BOOT MENU
b - Boot System
l - Run Loader
q - Power Down
POWER DOWN IN 60 SEC
242XU.104
The Boot Menu contains these commands:
Boot System If you did remove the batteries, make sure you install a charged main
battery pack or the terminal will not turn on. Press ! to boot the terminal. Once the
terminal is finished booting, your application appears on the screen.
Run Loader Press + to load the terminal firmware. To upgrade or load the firmware,
you should use the Firmware Upgrade option in the TRAKKER Antares 2400 Menu
System. For help, see “Upgrading the Firmware” in Chapter 3.
Power Down Press 0 to turn off the terminal. When you turn on the terminal, the
Boot Menu screen appears again if POST passes.
Resetting the Terminal
If the terminal or application is locked up and the terminal will not respond to any key
sequences, you can reset the terminal. Before you reset the terminal, try the following in
order:
• Press L to turn off the terminal.
• Scan the Reset Firmware label to restart the firmware and application.
Reset
*-.*
*-.*