Nugget
Co de 39
Troubleshooting
6-23
6
If the terminal or application still will not respond, reset the terminal.
To reset the terminal
• Scan the Boot Terminal label to reboot the terminal.
Boot Terminal
*-.1*
*-.1*
Or if the terminal will not scan you can perform this procedure:
1. Place the terminal on a flat surface.
2. Press
L
to turn off the terminal. If it will not turn off, continue with the next step.
3. Press and hold the
and
keys at the same time and then press
L
while still
pressing the other keys. The green scanner LEDs light and the terminal turns off.
Release the keys.
Tip: It helps to press the left side of the
key in this key sequence.
4. Press
L
to turn on the terminal. The Boot Menu appears.
BOOT MENU
b - Boot System
l - Run Loader
q - Power Down
POWER DOWN IN 60 SEC
242XU.104
Note: If the terminal returns to the exact same screen, the reset sequence did not
work. Repeat Step 1. Make sure you press and hold the
and
keys, and then
press the
L
key.
5. Press
!
to boot the terminal. Once the terminal has finished booting, your
application appears.
If the terminal still will not reset or boot, try loading the firmware. For help, contact your
local Intermec service representative.
To Next Page
Loading...
