Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-62
Host IP Address
Purpose: Defines the IP address assigned to the host computer in your 2.4 GHz RF network. An IP
address is a unique network level address you assign to each device in a TCP/IP direct
connect network. The host IP address you set on the T2425 must match the address that
is set on the host.
Syntax: NCn.n.n.n
where each n address segment is a number from 0 to 255. The host IP address field
consists of four separate numbers, each separated by a period.
Note: The RF network cannot be activated if the first address segment in the IP address
is set to 0, 127, or a number greater than 223.
Default: 0.0.0.0
Scan: To set the default host IP address, scan this bar code:
Default Host IP Address
*$+NC0.0.0.0*
*$+NC0.0.0.0*
Or: To set the host IP address:
1. Scan this bar code:
Enter Accumulate Mode / Set Host IP Address
*+/$+NC*
*+/$+NC*
2. Scan a numeric value from 0 to 255 to set an n field of the host IP address from these
bar codes.
*0* *1*
*0* *1*
*2* *3*
*2* *3*
*4* *5*
*4* *5*
*6* *7*
*6* *7*