Intermec Antares 2420 - Keypad Type

Co de 39
Nugget
Configuration Command Reference
9-67
9
Keypad Type
Purpose: The keypad type is initially configured in the terminal’s firmware at the Intermec factory.
If you change the keypad overlay, you must configure the keypad type to match the new
keypad overlay.
After you change the keypad type, you must save the configuration in flash memory and
boot the terminal for the change to take effect.
Note:
With the programmable keypad, you can access all the characters in the
“TRAKKER Antares Terminal Font Set” in Appendix C.
Syntax: KT
data
Acceptable values for
data
are:
0 Hardware (factory) default
1 Terminal emulation keypad
2 Programmable (English or European) keypad
Default: Hardware default
Scan: 1. Scan one of these bar codes:
Set Keypad Type to Hardware Default Set Keypad Type to TE Keypad
*$+KT0* *$+KT1*
*$+KT0* *$+KT1*
Set Keypad Type to Programmable Keypad
*$+KT2*
*$+KT2*
2. Scan this bar code to save the configuration change in flash memory:
Save Configuration in Flash Memory
*.+1*
*.+1*
3. Scan this bar code to boot the terminal and use the new keypad type:
Reset Firmware
*-.*
*-.*