Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
3-14
Exiting the TRAKKER Antares 2400 Menu System
1. From the Main Menu, press ? . If you have made any changes, the next screen
prompts you to store the changes in flash memory.
You can also save the runtime configuration in flash memory by choosing the Store
Configuration command from the System Menu. For help, see “Saving Configuration
Changes in Flash Memory” later in this chapter.
Note: When you boot or reset the terminal, it uses the configuration you last saved
in flash memory.
Store configuration
changes in flash
memory?
(used when rebooting
the terminal)
242XU.054
Yes No
CANCEL
2. Choose Yes and press  to save your changes in flash memory. Choose No and
press  to exit without saving. The Exiting TRAKKER Antares 2400 Menu
System screen appears.
Note: If you changed the configuration, you were prompted to save your changes in
RAM as you exited the Configuration Menu. If you want the configuration changes
to be stored in flash memory, you need to choose Yes in this screen.
Exiting
TRAKKER Antares 2400
Menu System
242XU.055
OK CANCEL