Co de 39
Nugget
Configuration Command Reference
9-11
9
Automatic Shutoff
Purpose: Defines the maximum length of time the terminal remains on when there is no activity.
When you do not use the terminal for the length of time set with this command, the
terminal automatically turns off as if you had pressed
L
to turn it off.
When you press
L
to turn on the terminal, the terminal either resumes exactly where it
was when you turned it off or the terminal boots and restarts your application. Resume is
controlled through the Resume Execution command. For help, see “Resume Execution”
later in this chapter.
Power Management Tip: You should use the Automatic Shutoff feature to preserve the
main battery pack’s power.
Syntax: EZdata
Acceptable values for data are:
0 Disabled (always on)
02-75 Shutoff time in minutes
Default: Disabled
Scan: To disable automatic shutoff, scan this bar code:
Disable Automatic Shutoff
*$+EZ0*
*$+EZ0*
Or: To set a timeout:
1. Scan this bar code:
Enter Accumulate Mode / Set Automatic Shutoff
*+/$+EZ*
*+/$+EZ*
To Next Page
Loading...
