Intermec Antares 2420 - Installing a Scan Module

Co de 39
Nugget
Learning How to Use the Terminal
2-39
2
Installing a Scan Module
To use the terminal, you must have a scan module installed on the terminal. The scan
module is installed at the Intermec factory.
You may want to change the scan module and install another type of scan module on the
terminal. Use these instructions to remove and install the scan module.
Note:
Observe all static electricity (ESD) precautions before installing a module.
To install a scan module
1. Make sure the terminal is off and then lay it face down on a clean and sturdy work
surface.
2. Use a Phillips screwdriver and remove the three screws that secure the scan module
to the terminal.
3. Remove the existing scan module from the terminal.
4. To install the module, align the module guides with the guides on the terminal.
Gently press down on the module to seat the connector guide pins and the module
connector into the connector on the terminal.
242XU.040
Scan module
Scan module
guide (2 places)
Terminal guide
(2 places)
Screw
Screw
Screw