Intermec Antares 2420 - Setting Preambles and Postambles

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
nugget
D-6
Setting Preambles and Postambles
With the
EM9560.BIN
application, you can set Preamble A, Preamble B, and Postamble
C on the T242X and make the terminal compatible with the 95XXs. The preambles are
prepended and the postamble is appended to the data that is transmitted through all the
serial ports.
Preamble A, Preamble B, and Postamble C can each be up to 25 ASCII characters in
length. If you enter a preamble or postamble command without entering data, the
preamble or postamble buffer is cleared.
Syntax: Preamble A AAdata or +.data
Preamble B ABdata or ++data
Postamble C ACdata or +%data
Scan: To set the preamble or postamble using the AA, AB, or AC configuration commands:
1. Scan one of these bar code labels:
Enter Accumulate Mode / Set Preamble A
*+/$+AA*
*+/$+AA*
Enter Accumulate Mode / Set Preamble B
*+/$+AB*
*+/$+AB*
Enter Accumulate Mode / Set Postamble C
*+/$+AC*
*+/$+AC*
2. Scan a value for
data
from the “Full ASCII Bar Code Chart” in Appendix B. The
preamble or postamble can be from 1 to 25 characters.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
4. Repeat Steps 1 to 3 to set another preamble or postamble.