Intermec Antares 2420 - RAM Drive Size

Co de 39
Nugget
Configuration Command Reference
9-87
9
RAM Drive Size
Purpose: Configures the size and use of the RAM drive (E). You can disable the RAM drive and
use the additional 256K for programmable (Malloc) memory allocations or configure the
RAM drive to temporarily store data and files.
After you set the RAM drive, you must save the configuration in flash memory and boot
the terminal for the change to take effect.
Note:
When you boot or reset the terminal, all files on the RAM drive are destroyed.
Syntax: FR
data
Acceptable values for
data
are:
0 Disabled, no RAM drive
16-256 RAM drive size in kilobytes (K)
Default: Disabled, no RAM drive
Scan: To disable the RAM drive, scan this bar code:
Disable RAM Drive
*$+FR0*
*$+FR0*
Or: To set the RAM drive size:
1. Scan this bar code:
Enter Accumulate Mode / Set RAM Drive Size
*+/$+FR*
*+/$+FR*