TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-86
Preamble (continued)
2. Scan a value for data from the “Full ASCII Bar Code Chart” in Appendix B. The
preamble can be from 1 to 25 characters.
Note: To scan a bar code label that includes quotes, you must configure the
terminal to use Code 39 in Full ASCII mode. For help, see “Code 39” earlier in
this chapter.
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Example: You want to set a preamble that includes quotation marks. To scan a bar code label that
includes quotation marks, you must configure the terminal to use Code 39 in Full ASCII
mode. For help, see “Code 39” earlier in this chapter.
Enter the preamble by scanning this full ASCII bar code label:
Set Preamble to “B”
*/D/KAD/B/B/BB/B/B/B*
*$+AD"""B"""*
You must enclose the data within quotation marks and precede each quotation mark with
another quotation mark so that the quotation marks are not treated as the end of the data.
To Next Page
Loading...
