Intermec Antares 2420

nugget
Using the Default Applications
D-9
D
Unsupported 95XX Features
These 95XX features are not supported by the
EM9560.BIN
application on the T242X.
• Display Setting configuration command (OD) (buffered or transparent display).
• Command Override reader (data entry) command (DLE).
• Right Host Message reader command (HT).
• Preamble A Required configuration command (OA).
• Computer Response Required Mode (CRRM) configuration command (PB), Enter
CRRM reader command (./), and Exit CRRM reader command (.-).
• Resume IRL configuration command (XG).
• Separate transmit and receive EOM characters (PI and PJ). The configurable EOM
(PF, YZ) is used for both transmit and receive EOM.
• Capacity reader command (%$).
• Forward and Review reader commands (%+ and %/).
• Download Program command from the 9154 or 9161 controller. Use the Transmit
File reader command. For help, see Chapter 8, “Reader Command Reference.”
Note:
Although these 95XX features are
not
supported, the T242X does have many
additional features (RF communications) that are not available on the 95XXs.
Running APPTSK.BIN and EM9560.BIN
There are two ways to run
APPTSK.BIN
or
EM9560.BIN
:
• Use the Run Program reader command.
• Use the TRAKKER Antares 2400 Menu System.
The instructions in this section explain how to use the Run Program reader command.
For help using the TRAKKER Antares 2400 Menu System to run an application, see
Chapter 5, “Using Custom Applications.”
To run APPTSK.BIN or EM9560.BIN on the terminal
1. Scan one of these bar code labels:
Run APPTSK.BIN
*/O/OC/ZAPPTSK/NBIN*
*//C:APPTSK.BIN*
Run EM9560.BIN
*/O/OC/ZEM9560/NBIN*
*//C:EM9560.BIN*