Intermec Antares 2420 - Time in Seconds

Co de 39
Nugget
Configuration Command Reference
9-115
9
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Time in Seconds
Purpose: If you enable the Append Time command, you can enable the Time in Seconds command
to append the seconds to each bar code label that is scanned on the terminal. To append
the time in hours and minutes, disable the Time in Seconds command.
Syntax: DA
data
Acceptable values for
data
are:
0 Disabled
1Enabled
Default: Disabled
Scan: One of these bar codes:
Disable Time in Seconds Enable Time in Seconds
*$+DA0* *$+DA1*
*$+DA0* *$+DA1*