Intermec Antares 2420

Co de 39
Nugget
Configuration Command Reference
9-3
9
This chapter is an alphabetical list of all the configuration commands supported on
the terminal.
Using Configuration Commands
A configuration command changes the way the terminal operates. For example, you can
change the Beep Volume command and make the terminal beep very loudly in a noisy
environment. You can execute configuration commands by
• scanning a command from a Code 39 or Code 93 bar code label. These labels are
provided in this chapter. For more help, see Chapter 3, “Configuring the Terminal.”
• choosing a command from the TRAKKER Antares 2400 Menu System. For help
using the menu system, see Chapter 3, “Configuring the Terminal.”
• sending a command from a device on the serial or RF network. For help, see “Using
Serial Communications on the Terminals” and “Using RF Communications on the
T2425s” in Chapter 4.
You can find the following information about each configuration command in this
chapter:
• Command description and purpose
• Command syntax and options
• Default setting
• Bar code labels you can scan to set or change each command
The configuration commands are listed alphabetically by command name. For a list of
bar code symbology, operations, serial network communications, or RF network
communications commands, use the next table, “Configuration Commands Listed by
Category.” If you want to look up a command by its syntax, see the “Configuration
Commands by Syntax” list in Appendix A.
Note:
The Code 39 bar code labels in this chapter show an asterisk (*) at the beginning
and end of the human-readable interpretation to represent the start and stop codes. If
you are creating your own Code 39 bar code labels, your bar code printing utility may
automatically supply the asterisks as the start/stop code.