Intermec Antares 2420 - Configuring the T2425 and the RF Network

nuggetf
code39
Getting Started
1-23
1
Configuring the T2425 and the RF Network
The T2425 can communicate with a host computer in Intermec’s 2.4 GHz RF network
either through the access points and the DCS 300 or directly through the access points.
The terminal ships with one of these RF network protocol options:
• UDP Plus
• TCP/IP
In a UDP Plus network, the terminal communicates through the DCS 300 to a host on an
Ethernet, token ring, twinaxial, coaxial, or SDLC network. In a TCP/IP network, the
terminal communicates through the access point directly to a host on an Ethernet or token
ring network.
Ethernet
Access point
TCP/IP
Direct Connect
UDP Plus
Access point
T2425 T2425
242XU.193
Host
DCS 300
Note:
All devices in the 2.4 GHz RF network must have an IP address. All access points
that the T2425 may communicate with must be in the same IP subnetwork. For help, see
Chapter 4, “Operating the Terminal in a Network.”