Intermec Antares 2420 - Understanding the Icons

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
2-18
Understanding the Icons
You can use the terminal’s icons to monitor the status of special keys, battery power,
saving data to flash memory, RF and network communications, and viewport movement.
As you use the terminal, the icons are turned on and off in the top line of the terminal
screen to indicate the current status.
242XU.114
Ctrl This icon appears when you press  . The key is stored in the
keypad buffer until you press another key. When you press a second key,
the key combination is entered into the terminal and the icon disappears.
242XU.118
Shift This icon appears when you press  . The key is stored in the
keypad buffer until you press another key. When you press a second key,
the key combination is entered into the terminal and the icon disappears.
242XU.117
Caps Lock This icon appears when you press  9 to enable the Caps
Lock feature and type all alphabetic characters as uppercase letters. When
you press  9 to disable Caps Lock, the icon disappears.
242XU.112
f
Function Left This icon appears when you press  . The key is stored in
the keypad buffer until you press another key. When you press a second
key, the key combination is entered into the terminal and the icon
disappears.
242XU.113
f
Function Right This icon appears when you press  . The key is stored in
the keypad buffer until you press another key. When you press a second
key, the key combination is entered into the terminal and the icon
disappears.
242XU.116
Radio This icon appears when the Network Activate command is disabled
on a T2425, or there is a problem with the radio card and it is turned off.
The Radio icon disappears when the network is enabled and the radio is on
and transmitting. For help, see Chapter 4, “Operating the Terminal in a
Network.”
•
242XU.108
Data This icon contains a period. It appears on the screen when data is
buffered in the RF interface. The data is either waiting to be transmitted to
the DCS 300 or host, or received data has not been accepted by the T2425’s
application. When no data is being buffered in the RF interface, the Data
icon is off.