Co de 39
Nugget
Learning How to Use the Terminal
2-19
2
Understanding the Icons (continued)
*
242XU.109
Connect This icon contains an asterisk and tells you if the T2425 is
connected via RF communications to the DCS 300 and/or an access point.
• If the Connect icon is not displayed, the T2425 is not connected to an
access point. You may be out of range of an access point or the terminal
may not be configured correctly. If the Network Activate command is
disabled, the Connect icon is not displayed, but the Radio icon does
appear.
• If the Connect icon blinks, the T2425 is not connected to the DCS 300.
You may be out of range of an access point, you may be about to go out
of range of an access point, or the access point may have recently been
turned off. The Connect icon does not blink in a TCP/IP network.
• If the Connect icon appears and remains on solid, the T2425 is
connected and communicating with the access point (TCP/IP) or
DCS 300 (UDP Plus).
In a UDP Plus network, the Connect icon is not instantaneously updated but
does tell you the communications status the last time data was sent or
received from the T2425. For help with network communications, see
Chapter 4, “Operating the Terminal in a Network.”
242XU.110
Battery This icon appears when one or both of the batteries have a low
power charge. The Battery icon appears with the terminal turned on or off.
• The Battery icon turns on and remains on and the terminal beeps every
15 seconds when the main battery pack has about 5 to 45 minutes of
power left.
• The Battery icon blinks when the backup battery charge is low.
• The Battery icon blinks and the terminal beeps every 15 seconds when
both batteries are low.
The Battery icon disappears when you replace or charge the main battery
pack, or charge the backup battery. For help, see “Learning About the
Terminal’s Batteries” later in this chapter.
242XU.111
Viewport This icon appears when you move the viewport out of the upper
left corner of the screen, which is the viewport’s home position. When you
move the viewport back to the home position, the icon disappears.
To Next Page
Loading...
