nuggetf
code39
Getting Started
1-11
1
Installing the Main Battery Pack
Install the fully charged main (lithium-ion) battery pack into the terminal.
Note:
You should always keep a charged main battery pack installed in the terminal to
maximize the backup battery’s life.
To install the main battery pack
1. If the battery door is not off, open the battery door by pushing down on the battery
door latch and sliding it toward the bottom end of the terminal. Lift up the top edge
of the battery door to remove it.
242XU.079
Battery door
latch
TOP
BOTTOM
2. Hold the battery pack with the flat side facing down toward the inside of the battery
compartment. The small arrow on the top of the battery pack must point toward the
top (screen) end of the terminal.
3. Place the battery pack into the upper (larger) half of the battery compartment.
To Next Page
Loading...
