TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-106
Stop Bits
Purpose: Sets the number of stop bits on the serial port.
Syntax: YCn.data
where n is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for data are:
1 1 stop bit
22 stop bits
Default: 1
Scan: One of these bar codes:
1 Stop Bit for COM1 2 Stop Bits for COM1
*$+YC1.1* *$+YC1.2*
*$+YC1.1* *$+YC1.2*
1 Stop Bit for COM3 2 Stop Bits for COM3
*$+YC1.1* *$+YC1.2*
*$+YC3.1* *$+YC3.2*
1 Stop Bit for COM4 2 Stop Bits for COM4
*$+YC4.1* *$+YC4.2*
*$+YC4.1* *$+YC4.2*
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
ICdata
where data is value of 1 or 2.
To Next Page
Loading...
