Intermec Antares 2420 - Set Time and Date; Test and Service Mode

Nugg
Co de 39
Reader Command Reference
8-13
8
Set Time and Date
Purpose: Sets the time and date on the terminal. When the terminal receives the time broadcast
command from the 9154 or 9161 controller, the command sets the clock on the terminal.
You can configure the clock with seconds or without seconds.
Use this command only for backward compatibility with the 95XX terminal. If you do
not need backward compatibility, use the Time and Date configuration command. For
help, see “Time and Date” in Chapter 9.
Note:
The Set Time and Date command was called Enable Clock for the 95XX
terminals.
From Network: /+
data
Acceptable formats for data to set the times and date are:
yy/mm/dd:hh:mm:ss
yy/mm/dd:hh:mm
hh:mm:ss
hh:mm
Year values (
yy
) from 00 to 95 are interpreted as 2000 through 2095. Year values from
96 to 99 are interpreted as 1996 through 1999.
Keyboard: Not supported.
Label Syntax: You can create your own bar code labels to set the time and date by creating a bar code
in this command format:
/+ data
where
data
is one of the formats listed above.
Test and Service Mode
Purpose: Starts the TRAKKER Antares 2400 Menu System. From the Main Menu, the
Diagnostics Menu is the Test and Service mode you can use to run software, hardware,
and system diagnostics on the terminal. For help, see Chapter 7, “Running Diagnostics.”
From Network: Not supported
Keypad: T3, or T
Scan:
Test and Service Mode
*..-.*
*..-.*