Intermec Antares 2420 - Recording Your Terminals Configuration

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
3-24
Recording Your Terminal’s Configuration
The tables in this section list all the configuration parameters, their options, and where to
find them in the Configuration Menu of the TRAKKER Antares 2400 Menu System. The
default setting for each parameter is shown in bold italics.
You should have an accurate record of the terminal’s configuration settings in case the
terminal’s volatile memory and the configuration setup are lost. Record the configuration
on these pages by circling the option you chose for each parameter or writing the value.
Bar Code Symbologies Table
Parameter (Syntax) Options Location in Configuration Menu
Codabar (CD)
Disabled
ABC
Standard
Concatenated
Symbologies Menu,
Codabar option
•
Start/Stop digit
Discard
Retain ABCD
Retain DC1-DC4
Code 11 (CG)
Disabled
One check digit
Two check digits
Symbologies Menu,
Code 11 option
Code 16K (CP)
Disabled
Standard
Function code 1
Symbologies Menu,
Code 16K option
Code 2 of 5 (CC)
Disabled
3 bar start/stop, label length
2 bar start/stop, label length
Symbologies Menu,
2 of 5, I2 of 5 option
Code 39 (CB)
Disabled
No check digit
Check digit
HIBC
AIAG check digit
Symbologies Menu,
Code 39 option
•
Check digit
Discard
Retain
•
ASCII
Non-full
Full
Mixed-full
Symbologies Menu,
Code 39 option
Code 49 (CJ)
Disabled
Enabled
Symbologies Menu,
Code 49 option
•
Function Code 1 (CK)
None (disabled)
Any two ASCII characters