Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugg
Co de 39
7-12
Destructive RAM Test
Purpose: Use the Destructive RAM Test if you have any problems storing files on the RAM drive
or running an application that uses RAM memory.
Where Available: Choose the Main Board Menu from the Hardware Diagnostics menu.
Sample Screen:
242XU.143
DESTRUCTIVE RAM TEST
The following test
will cause the unit
to reboot, causing
loss of all RAM
resident data.
PROCEED?
PRESS 'Y' to
proceed...
[Esc] Exit
Memory Test Passed
Pass #: 00037
Press a key
to Reboot Unit
Definition: Before you run this test, save your data. If you are running a TE application, end your
current TE session. Press 8 to start the test. All data in RAM will be lost. The terminal
starts the RAM test and clears the screen. You hear a beep after a successful test of each
64K block of data. After 15 beeps, a test pass is complete and the results appear. The
sample screen shows a successful test pass.
To run another test pass, do not press a key and the next test begins after a 5 second
pause. You may let the test continue and test the RAM several times to get a test over
time. To exit the test, press  once a test pass is complete. The terminal reboots and
restarts your application.
If an error is found, the Destructive RAM Test stops and displays the error address, the
data written to RAM, and the data read from RAM. Note this information and contact
your local Intermec service representative.
Caution
If the Destructive RAM Test fails, stop using the terminal. Contact your local
Intermec service representative.
Conseil
Si le test Destructive RAM échoue, veuillez ne plus utiliser le terminal. Contactez le
représentant du service clientèle Intermec de votre région.