Intermec Antares 2420 - Baud Rate

Co de 39
Nugget
Configuration Command Reference
9-13
9
Baud Rate
Purpose: Sets the baud rate for the serial port on the terminal. The baud rate must match the baud
rate of the device (i.e., the host computer) that the terminal is communicating with
through the serial port.
Syntax: YA
n
.
data
where
n
is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for
data
are:
3 1200 baud
4 2400 baud
5 4800 baud
6 9600 baud
7 19200 baud
8 38400 baud
Note:
For COM3 ports, the maximum baud rate is actually 33600 baud.
Default: 19200
Scan: To set the default baud rate for each serial port, scan these bar codes:
Default Baud Rate for COM1 Default Baud Rate for COM3
*$+YA1.7* *$+YA3.7*
*$+YA1.7* *$+YA3.7*
Default Baud Rate for COM4
*$+YA4.7*
*$+YA4.7*
Or: To set the baud rate for one serial port:
1. Scan this bar code:
Enter Accumulate Mode/Set Baud Rate
*+/$+YA*
*+/$+YA*