Intermec Antares 2420

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
N
ugg
Co de 39
8-12
Scanner Trigger On and Off
The Scanner Trigger On and Off commands are the same as pushing and releasing the
Scan button on the keypad. The Scan button and scanner trigger commands control the
integrated scanner on a laser scan module.
Note: The Scanner Trigger On and Off commands do not activate the scanner device
connected to the module for cabled scanners.
After a Scanner Trigger On command, the scanner operates differently depending on the
Scanner mode and scanner trigger configuration settings:
• If you configure the terminal to use One-Shot Scanner mode and level triggering, the
scanner automatically turns off after a good read of a bar code label, or after the
scanner timeout period elapses.
• If you configure the terminal to use Automatic Scanner mode and level triggering, the
scanner remains on after a good read of a bar code label. You can use the Scanner
Trigger Off command to turn off the scanner, or set the Scanner Timeout command
to automatically turn off the scanner after it stays on for the period of time set.
For help on configuring the Scanner Mode or Scanner Trigger commands, see Chapter 9,
“Configuration Command Reference.”
Note: Intermec does not recommend that you use a Scanner Trigger On or Off
command with the Scanner Trigger command set to edge triggering.
Purpose: The Scanner Trigger On command is the same as pushing the Scan button.
From Network: /.
Keypad: Not supported
Scan: Not supported
Purpose: The Scanner Trigger Off command is the same as releasing the Scan button. Its effect
depends on the Scanner mode and Scanner Trigger mode configuration settings as
described earlier.
From Network: /%
Keypad: Not supported
Scan: Not supported