Intermec Antares 2420 - Page 324

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-56
End of Message (continued)
Or: To set EOM to one or two ASCII characters for one serial port:
1. Scan this bar code:
Enter Accumulate Mode / Set EOM
*+/$+YZ*
*+/$+YZ*
2. Scan one of these bar codes to set the COM port:
COM1 COM4
*1.* *4.*
*1.* *4.*
3. Scan one or two bar codes for data from the “Full ASCII Bar Code Chart” in
Appendix B.
4. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5. Repeat Steps 1 through 4 to set the EOM for another serial port.
Notes: For COM1 only. To provide compatibility with earlier TRAKKER Antares firmware
versions, you can also use this syntax:
PFdata
where data is one or two ASCII characters.